View source for Aluminum

<!-- Make sure to add categories as appropriate -->
{{warning|This page has not been released yet.}}
{{#vardefine:restriction|0}} <!-- Set the Material Restriction Level: 1 = CMOS Clean, 2 = Semi-Clean, 3 = Metals, 4 = varies -->
{{Infobox material
|image      =
|caption    = 
|category   = 
|properties =
|names      =
}}

Aluminum is a metal that is a silvery-white, soft, non-magnetic and ductile in the boron group. 
==Applications==
*Discuss common uses/applications for this material. Why this materials is used in the LNF?

==Processing Tools==
Process technologies that can be used to deposit/pattern this material.  If this is a substrate, refer to what tool/process restrictions there may be and possibly remove the following sub-sections.

===Deposition Equipment===
*[[Lab 18-2]]
*[[Enerjet Evaporator]]
*[[Angstrom Engineering Evovac Evaporator]]
*[[PVD 75 Proline]]

===Etching Equipment===
*[[Acid Bench 12]] - maintained tank
*[[Acid Bench 73]] - Beaker
*[[Acid Bench 82]] - Beaker

==Processes==
====[[Electron_beam_evaporation|E-beam evaporation]]====
* [[Angstrom Engineering Evovac Evaporator]]
* [[Enerjet Evaporator]]
* [[SJ-20 Evaporator]]

====[[Sputter_deposition|Sputter deposition]]====
* [[Lab 18-1]]
* [[Lab 18-2]]
* [[PVD 75 Proline|PVD 75]]

===Etch Processes===
====[[Wet etching|Wet etching]]====
Wet etching can be used to etch aluminum using [[Aluminum Etch]]
*[[Acid Bench 12]]
*[[Acid Bench 73]]

==References==
*'''Etch rates for micromachining processing''' https://ieeexplore.ieee.org/abstract/document/546406
*'''Etch rates for micromachining processing-Part II''' https://ieeexplore.ieee.org/abstract/document/1257354