Oxford OpAL ALD
|Oxford OpAL ALD|
|Material Processed||Al2O3, HfO2, ZnO|
|Sample Size||8", 6", 4", 3" and 2" wafers, pieces|
|Supported Processes||Supported Processes|
The Oxford OpAL is a plasma or thermal assisted atomic layer deposition (ALD) tool used to deposit Al2O3, ZnO, and HfO. It is an open loop (non-loadlocked) tool which had two channels for metal organic precursors, one channe1 for water and a plasma head.
- Update this with announcements as necessary
- Highly conformal and uniform metal-oxide thin films with no pinholes
- Slow growth rate with monolayer-level thickness control.
- Single open-loop vacuum chamber with heated table and heated sidewalls
- 8.25" Heated table can run 80-300ºC
- Two metal-organic bubbler channels with jacket heaters and millisecond-firing ALD valves. (One channel dedicated to Al2O3. Second channel runs HfO2 and ZnO is available rarely.)
- Downstream 300 W RF plasma head with isolation valve
- Software to run loops of dose/purge cycles to enable ALD
- 8.25" Diameter circular, flat table.
- Substrates must be able to handle 100ºC heating.
- Due to aggressive pumping/purging very small samples or powders not recommended.
The Oxford OpAL ALD is designated as a Metals class tool. Below is a list of approved materials for the tool. Approved means the material is allowed in the tool under normal circumstances. If a material is not listed, please create a helpdesk ticket or email firstname.lastname@example.org for any material requests or questions.
- Three films are Availible
Recipe Summaries are outlined the the ALD Standard Processes page
Standard Operating Procedure
Widget text will go here.
- Read through this page and the Standard Operating Procedure above.
- Create a Helpdesk Ticket requesting training.
- A tool engineer will schedule a time for initial training.
- Practice with your mentor or another authorized user until you are comfortable with tool operation.
- Schedule a checkout session with a tool engineer via the helpdesk ticket system. If this checkout is successful, the engineer will authorize you on the tool.
The ALD has maintenance based on total deposition:
- The ALD bubblers are replaced based on usage (typically 25000-30000 cycles for Al2O3)
- The chamber dome and ceramic tube are removes and sandblasted, typically on bubbler changed (approximately once every 6-8 months.)
- Tool leak checks, pumping speeds and film characterization are done periodically or when major tool changes are done.
Tool Pumping Performance
3 Films are run the ALD - Al2O3 is always available. Typically HfO2 is in the second channel (Source 4) but occaisionally ZnO is installed
Power Bump Recovery
The only maintenance that users are allowed to perform is power interruption recovery.
- Follow the power bump part of the Oxford ALD Startup and Shutdown Procedure