Difference between revisions of "Plasmatherm 790"
|Line 61:||Line 61:|
Below is a list of approved and restricted materials for the . "Approved" means the material is allowed in the tool under normal circumstances. "Not Allowed" means the material may never be used in the tool. If a material is not listed, it may be possible to use the material under certain conditions. Please contact a tool engineer via the helpdesk ticket system for any material requests or questions.
Below is a list of approved and restricted materials for the
Revision as of 09:46, 19 May 2015
This article's lead section may not adequately summarize key points of its contents.
|Material Processed||Si, SiO2|
|Mask Materials||PR, SiO2|
|Gases Used||He, O2, SF6|
|Supported Processes||Supported Processes|
|User Processes||User Processes|
|Warning:||This page has not been released yet.|
The Plasmatherm 790 is a dual chamber parallel plate tool. The left chamber is configured for reactive ion etching (RIE) while the right chamber is configured for plasma enhanced chemical vapor deposition (PECVD). The RIE chamber is one of the slower etchers in the lab, especially compared to the P5000 RIE. The main advantage is that there are almost no material restrictions, so a wide variety of materials can be processed. The PECVD is also much slower compared to the P5000 PECVD; this can actually be advantageous as the smaller building blocks can improve a films quality.
- [2014-09-25] - Added 500 sccm Helium MFC to PECVD chamber.
- Wide variety of materials processed
- Wide variety of gases available
- Generally slower etch rates <1000 Å/min
- RIE Gases
- PECVD Gases
- RIE: 5 - 300 mTorr
- PECVD: 50 - 2000 mTorr
- PECVD: Heated Platen: 200°C - 350°C
- 400 W 13.56 MHz RF Source
- Up to 3 100 mm (4") wafers
- Pieces don't require mounting
- 1 150 mm (6") wafer
- 2 100 mm (4") wafers
- Several pieces
The Plasmatherm 790 is designated as a metals class tool. Below is a list of approved and restricted materials for the Plasmatherm 790. "Approved" means the material is allowed in the tool under normal circumstances. "Not Allowed" means the material may never be used in the tool. If a material is not listed, it may be possible to use the material under certain conditions. Please contact a tool engineer via the helpdesk ticket system for any material requests or questions.
This section requires expansion with: the process subpages are incomplete.
There are several processes for this tool supported by the LNF, which are described in more detail on the Processes page.
In addition to these, this tool has a number of user-created recipes for etching a wide variety of materials. Some of these recipes are documented on LNF User:Plasmatherm 790 User Processes. If you are curious if your material can be processed in this tool, please contact the tool engineers via the helpdesk ticket system.
Standard Operating Procedure
Widget text will go here.
- Read through the Standard Operating Procedure above.
- Complete the training request form here.
- Create a helpdesk ticket requesting training.
- A tool engineer will schedule a time for initial training.
- Practice with your mentor or another authorized user until you are comfortable with tool operation.
- Complete the SOP quiz here.
- Schedule a checkout session with a tool engineer via the helpdesk ticket system. If this checkout is successful, the engineer will authorize you on the tool.
Every other week a light cleaning is performed on the tool. A 5 min etch with m_si_o_1 is performed on a 4" oxide wafer as a qualification run. The results can be seen below.