Difference between revisions of "STS APS DGRIE/Processes/uk submicron etch"
|Line 39:||Line 39:|
Revision as of 15:08, 18 August 2015
|Warning:||This page has not been released yet.|
|About this Process|
|Equipment||STS APS DGRIE|
|Mask Materials||SPR 220, KMPR, Polysilicon|
|Gases Used||C4F8, He|
|Authored By||SPTS, Kevin Owen|
The uk submicron etch is designed for thin-film (up to 8 μm) etching of silicon dioxide. Etch rate up to 2600 Å/min, depending on feature size. The etch exhibits extremely vertical sidewalls and can achieve down to 100 nm feature resolution.
Follow the SOP as shown on the STS APS DGRIE page and choose the uk_submicron etch.
Detailed characterization data for the etch can be found here.
Etch rate is feature size dependent - smaller features will etch slower than larger ones. Bulk etch rate is approximately 2600 Å/min. The etch exhibits minimal loading effect.
Etch uniformity is < 1% across a 6" wafer.
The etch rate of SPR 220 is approximately 100 nm/min, giving a selectivity of ~2.5:1. Selectivity will be lower on smaller features, due to the decrease in oxide etch rate.
The etch may be run for a maximum of 30 minutes.
The bulk oxide etch rate is tested after each maintenance (every 1-2 weeks) by running a 2 min etch on an oxide coated 6" wafer and measured at 25 points around the wafer.