Difference between revisions of "STS Pegasus 4/Processes/LNF O2 Descum"
< STS Pegasus 4 | Processes
Jump to navigation
Jump to search
(Created page with "<!-- Make sure to add any other relevant categories --> {{#ifeq: {{NAMESPACE}} | Template | | Category:Processes}} {{warning|This page has not been released yet.}} {{Infob...") |
|||
| Line 29: | Line 29: | ||
| ICP Power | | ICP Power | ||
| W | | W | ||
| − | | | + | | 2500 |
|- | |- | ||
| − | | Bias Power | + | | Bias Power (LF) |
| W | | W | ||
| − | | | + | | 75 |
|- | |- | ||
| Bias Pulsing | | Bias Pulsing | ||
| Hz | | Hz | ||
| − | | | + | | none |
|- | |- | ||
| Pressure | | Pressure | ||
| mTorr | | mTorr | ||
| − | | | + | | 20 |
|- | |- | ||
| O<sub>2</sub> Flow | | O<sub>2</sub> Flow | ||
| sccm | | sccm | ||
| − | | | + | | 200 |
| + | |- | ||
| + | | Ar Flow | ||
| + | | sccm | ||
| + | | 100 | ||
|} | |} | ||
Revision as of 16:31, 22 November 2020
 Warning: | This page has not been released yet. |
| About this Process | |
|---|---|
| Process Details | |
| Equipment | STS Pegasus 4 |
| Technology | RIE |
| Material | all |
| Mask Materials | none |
| Gases Used | O2 |
LNF O2 Descum uses an O2 plasma to isotropically remove polymers. It is intended as a photoresist descum prior to etching, although it may oxidize expose surfaces. The LNF Ar Descum is better suited for normal circumstances. This recipe may also be used for photoresist mask stripping post process, although there are other systems at the LNF with better performance for this process.
Contents
Procedure
Follow the standard operating procedure. This recipe may also be added as an additional step within another recipe. Create a helpdesk ticket for assistance.
The maximum etch time allowed for this process is 5 minutes.
Parameters
| Parameter | Units | Setpoint |
|---|---|---|
| ICP Power | W | 2500 |
| Bias Power (LF) | W | 75 |
| Bias Pulsing | Hz | none |
| Pressure | mTorr | 20 |
| O2 Flow | sccm | 200 |
| Ar Flow | sccm | 100 |
Capabilities
Etch rate and uniformity
| Material | Etch Rate | Uniformity |
|---|---|---|
| SPR 220 | 7800 Å/min | 6% |
| Silicon dioxide | 30 Å/min | 5% |
| Silicon nitride | ? | ? |
| Silicon | ? | ? |
Mask Selectivity
This recipe is intended for blanket descum of the wafer surface, so a mask is not necessary.
Limitations
Maximum allowed etch time is 5 min.
