STS Pegasus 4/Processes/LNF Oxynitride LF
|About this Process|
|Equipment||STS Pegasus 4|
|Material||Si, SiO2, Si3N4|
|Gases Used||SF6, C4F8, Ar|
|Authored By||Brian Vanderelzen|
The LNF Oxynitride LF is a legacy recipe on the STS Pegasus 4 and 6 that may be used to etch silicon dioxide and silicon nitride. Because the tool is not designed for this process, it also etches silicon and photoresist at a similar rate. It is primarily useful for native oxide removal prior to a deep Si etch. For oxide film etching, such as preparing an etch mask, the STS Glass Etcher and P5000 RIE have far superior performance and are strongly recommended. It is not actively maintained by the LNF.
Follow the SOP outlined on the tool page. LNF Oxynitride LF should not be run for longer than 30 min.
|Bias Pulsing||Hz||40 Hz - 50%|
|Silicon dioxide||1090 Å/min||5.1%||?|
|Silicon nitride||1350 Å/min||4.3%||?|
|Low stress nitride||1220 Å/min||4.4%||?|
|SPR 220||1520 Å/min||5.9%||?|
Widget text will go here.
This process is not recommended for most etch processes. There are other RIE tools in the lab with much better performance for oxide and nitride etching with higher selectivity to silicon and photoresist. Please create a helpdesk ticket or email email@example.com if you have further questions.